Installation Instructions - cobra standard

PDF files
available under cobra -Download

 

1. Install the expansion insert

Choose the appropriate length. Compress the rope at a distance of the branch circumference plus 20 cm from the end of the rope and insert the expansion insert through the braids into the rope.

2. Cut the anti-friction hose to length and pull it over the rope.

Length = at least the circumference of the branch

3. Create quick splice

After slinging the rope around the branch, feed the end of the rope about 30 cm through the inside of the rope (distance from the stem about ½ of the stem diameter) and then lead it out again.

4. Create a compensation loop

Form a loop with a diameter of about 10 cm; then feed the end of the rope again about 10 cm through the inside of the rope and lead it out. This loop shall serve for tensioning, as growth reserve and for inspection.

5. Insert the shock absorber

Compress the rope at a convenient spot and insert the shock absorber into the rope through the braids.

6. Cut the rope to length and shrink on the end caps

Pull the end cap at least 10 cm over the end of the rope. Heat the end of the rope with a torch until slight crimping occurs. Then push the end cap back to the end and shrink it on there.